Gas tank, tankless and heat pump water heaters installed by in-house, Navien-certified technicians. A standard tank replacement takes 2 to 3 hours.
Tank, tankless or heat pump, any size. Removal, installation, permit and haul-away included. Offer ends December 31, 2026.
Price covers a standard swap: the old unit comes out and the new one goes in at the same spot. It applies when no panel upgrade and no line relocation are needed. Any extra work your home needs is quoted in writing before we start.
We install gas tank, gas tankless and heat pump water heaters from Navien, Rheem, Bradford White, Rinnai, Noritz and A.O. Smith, sized to your household's hot water demand.
A reliable, lower-cost option for most South Bay homes. We size the new unit and confirm the venting and gas line meet current code.
Continuous hot water from a compact wall-mounted unit, planned around gas line sizing and venting. Tankless installation
The most efficient option and the one that qualifies for utility rebates. Heat pump installation
The old unit is disconnected, drained and hauled away, and we check the area around it for wear while everything is open.
Something wrong with the unit you have now? See water heater repair.
A gas tank has the lowest upfront cost and the simplest maintenance, but hot water is limited to what the tank holds and it takes more space. Most tanks last 8 to 12 years.
A tankless unit costs more upfront, mounts on the wall and heats water on demand, so it does not run out. It needs regular flushing and usually lasts 15 to 20 years or more.
A heat pump water heater is the most efficient of the three and often qualifies for the largest rebate, which lowers the net cost. It needs more space and good airflow around it. See heat pump rebates.
Replacing a water heater requires a city plumbing permit, and the city inspects the finished installation. A JetPipe team member meets the inspector on site.
We register the manufacturer's product warranty before we leave, so it is on file if you ever need it. Our installation work carries a one year labor warranty.
The written price covers removal of the old unit, the new equipment, labor and the permit, so there are no surprise charges once the job is underway.
The inspection follows a set list, and we build every install to it. This is Sunnyvale's checklist. San Jose and other South Bay cities enforce the same California code with their own local details.
One in the top third of the tank and one in the bottom third.
Runs to the outside of the house and points down, so a discharge never ends up in a crawl space.
Double-wall metal vent pipe with clearance from anything combustible, ending above the roof under a listed cap.
Installed on the gas line just ahead of the water heater.
Enough air for the burner, whether the unit sits in a garage or in a closet.
Burner and controls sit at least 18 inches above the floor, unless the unit is rated flammable vapor ignition resistant.
A gas tank replacement is a short job, and most of it happens in one visit. Heat pump installs are scheduled once the city permit is approved.
Tell us what is happening: no hot water, a leaking tank or a unit near the end of its service life.
The technician looks at the existing unit, the gas line, the venting and the space around it, then walks you through your options.
You approve the price before work starts. It covers removing the old unit, the new water heater, labor and the permit.
Replacing a water heater requires a city plumbing permit. Sunnyvale and San Jose both issue it online.
The old tank is hauled away and the new one is set, strapped, connected and tested. A standard tank replacement takes 2 to 3 hours.
The city inspects the finished installation, and a JetPipe team member meets the inspector on site.
Real installs we have completed across the South Bay and the Peninsula.







Free Estimate
Tell us what you have now and what is happening, and we will confirm the options, the permit and the timing.
Instant Quote
Answer a few questions about your home and get a personalized estimate online.
We are based on Stewart Drive in Sunnyvale and cover the South Bay and Peninsula
from there. If your city is not on the list, call us anyway. We often work just outside our
usual range.
The map shows where we work most weeks, not a fence. We are based in Sunnyvale and we regularly take jobs just outside it. One call tells you whether we can reach you and when.
A standard tank replacement takes 2 to 3 hours. A tankless install is usually finished in one day when no utilities need to be moved. A heat pump installation takes 3 to 5 hours once the city permit is approved.
Yes. Sunnyvale and San Jose both require a plumbing permit to replace a water heater, and the city inspects the finished installation. The permit cost is included in the written price.
We work with Navien, Rheem, Bradford White, A.O. Smith, State and other major brands, and help you pick the one that fits your home and budget.
Usually, yes. A tankless unit needs a properly sized gas line and its own venting, so we check your existing setup before recommending a specific approach.
Yes. Removal and disposal of the old unit is included in every installation.
Yes, financing is available. You get the written price first, then decide how to pay. See financing options.
Fill this out and we will call you back with a real answer: what it usually turns
out to be, what it takes to fix, and what it costs. No charge for the
conversation.
GET A FREE ESTIMATE