Water Heater Installation and
Repair in Burlingame, CA
Gas tank, gas tankless and heat pump units, installed and repaired by JetPipe, a family owned plumbing company. Our permit department pulls the city permit, an employee attends the inspection, and we help with the rebate paperwork.
Water Heater Installed for $5,500, Regular Price $8,000
Tank, tankless or heat pump, any size. Removal, installation, permit and haul-away included. Offer ends December 31, 2026.
See Offer details
Price covers a standard swap: the old unit comes out and the new one goes in at the same spot. It applies when no panel upgrade and no line relocation are needed. Any extra work your home needs is quoted in writing before we start.
Four Options, and What Usually Decides Between Them
Which unit makes sense for your house depends less on preference than on three practical things: where the heater sits, what the gas line can carry, and what the electrical panel can support. We work that out on site before anything gets ordered.
The straight swap. Same footprint, same connections, and in a normal garage setup the water heater installation is done within a morning.
Wall mounted, hot water that does not run out, and a larger gas supply than a tank needs. We size and upgrade the gas line as part of a tankless water heater job rather than discovering it halfway through.
A heat pump water heater is the most efficient option and the one the WestLight rebate is built around. It also comes with the most conditions attached, which the next two sections cover.
Not every failure is a replacement. A thermocouple, a pilot assembly, a relief valve or a control board is often the whole problem, and water heater repair is the cheaper road.
Navien, Rinnai, Noritz, Rheem, Bradford White and A.O. Smith. We are a certified Navien installer.
In Burlingame the Rebate Comes From WestLight Energy
Burlingame homes get gas and power delivered by PG&E, and the electricity itself comes from WestLight Energy, the San Mateo County energy agency that used to be called Peninsula Clean Energy. WestLight runs the heat pump water heater rebate here, up to $3,500 when a heat pump replaces a gas water heater. We confirm current amounts at the estimate.
The paperwork matters as much as the unit. The rebate file needs the invoice and proof that the permit passed inspection, which is why the permit and the rebate belong with the same people. Our permit department prepares the file as part of the job.
The rebate is paid once WestLight approves the file, usually within one to six months. You pay the install cost upfront either way. We prepare the paperwork and walk you through each step, and we confirm what applies to your address at the estimate.
The Electrical Panel Decides More Than the Brand Does
A heat pump water heater normally wants a dedicated two hundred and forty volt circuit. In older Burlingame houses the panel does not always have room for one, and at that point a water heater job quietly turns into an electrical job, with a different timeline and a different number at the bottom.
There is a way around it. Plug-in models that run from a standard household outlet exist and we install them, which avoids the panel upgrade altogether. They heat more slowly than the higher voltage units, so they suit a household that is not pulling hot water in three places at once. Whether that describes your house is something we answer at the estimate rather than over the phone.
Our permit department runs the load calculation before anything is ordered. If your panel supports the unit as it stands, we tell you. If it does not, we tell you that too, along with what the alternative actually looks like. We confirm what the city asks for on your project at the estimate.
Where the Heater Lives Changes the Job
Two houses on the same street can need different units for no reason other than the closet the old one was standing in.
The common case in the midcentury and ranch homes of Ray Park, Mills Estates and Burlingame Hills. Room to work, somewhere for the condensate to go, and the easiest situation for a heat pump, which needs surrounding air to pull heat from, so we plan staging before the truck arrives.
Common in the early houses of Easton Addition, Burlingame Park and the streets around downtown, where an old gas tank often stands in a hall closet or a utility room. Tight, often without a floor drain, and a heat pump tucked into a closet will underperform unless it is ducted. A tankless unit on an exterior wall is frequently the better answer in these houses.
Common in townhomes. Clearances and venting decide what will physically fit, which is why we measure before quoting rather than after.
In townhome and condo communities, anything touching an exterior wall usually needs written approval from the association first. We tell you that at the estimate so it does not surface on install day.
From the Estimate to the Inspection
A like-for-like gas tank replacement is often a one day job once the permit is in place. Tankless units, relocations and bigger changes take more city review, so they take longer to schedule.
A heat pump install runs differently and it is better to know that upfront. The permit has to be in place before install day, so same day applies to the estimate rather than to the installation. The install itself takes three to five hours once those are in place. The city inspection comes afterward. Our permit department pulls the permit and one of our employees attends the inspection with the paperwork, so you do not need to be home for it and you are not the one fielding questions about work you did not perform.
Water Heaters We Have Installed
Real jobs we have completed. No stock photos, no borrowed before and after shots.







Free Estimate
Get a Free Estimate on Your New Water Heater
Tell us about your home and we will confirm the right unit, the permit and the rebate details at the estimate.
Financing is available through Synchrony. You pay exactly the amount on our invoice. Subject to credit approval.
400+ reviews from Bay Area homeowners
Neighborhoods We Cover in Burlingame
JetPipe is based in Sunnyvale and serves Burlingame, and most Burlingame
addresses are a short drive rather than a trip across the valley. If your street is not
listed below, call anyway. We are usually closer than you expect.
The map shows where we work most weeks, not a fence. We are based in Sunnyvale and we regularly take jobs in Burlingame. One call tells you whether we can reach you and when.
How long does the install actually take?
Hours, not days, for the installation itself. A like-for-like gas tank swap runs two to three hours in a normal garage setup, and tankless and heat pump installs run three to five. Permits are handled before install day, and if the gas line or the venting has to change, you will hear about it at the estimate rather than on the day.
Do I have to deal with the old tank myself?
Not at all. Removing the old unit and disposing of it is part of the job, not an extra line at the end, so the old tank leaves when we do.
Do you install tankless water heaters?
Gas models, from the brands we carry. The gas supply is the first thing we check, because a tankless unit asks for a bigger line than a tank does, and we upgrade it as part of the same job rather than discovering the shortfall on install day.
My tankless was put in by someone else. Will you still service it?
Yes, whoever installed it. We repair and descale units we did not put in, across all the brands we carry.
Which brands do you work with?
Six that we install regularly: Navien, Rinnai, Noritz, Rheem, Bradford White and A.O. Smith. As a certified Navien installer, we configure tankless units to manufacturer spec, which protects the warranty.
Do I need a permit to replace a water heater in Burlingame?
Yes, Burlingame requires one for a water heater replacement, and we handle it. Our permit department pulls the permit, and one of our employees attends the inspection, so you do not need to be home for it. If you are switching to a heat pump, the passed inspection also goes into the WestLight rebate file.