Whole House Repiping
in Burlingame, CA
Copper and PEX repipes for Burlingame homes, from early houses with galvanized lines to midcentury homes and newer builds. Every repipe is permitted and inspected, one of our people attends the inspection, and we patch the drywall. Family owned, licensed C-36 plumbing contractor.
25-Year Warranty on Whole House Copper Repiping
Every joint, fitting, and connection we install is covered. Parts and labor included.
Three Symptoms That Usually Mean the Pipe, Not the Fixture
A single fixture running weak is a fixture problem. The whole house losing pressure the moment a second tap opens is a supply problem, and in older pipe it means the working diameter has closed up.
Water standing overnight in corroding pipe picks up what it is standing in. If it clears after running for a minute and comes back the next morning, the pipe is telling you something.
One pinhole is a repair. A second one in a different room within the year is the system reaching the end of its service life, and patching each new leak as it appears is the expensive way to replace a house.
What We Find Behind the Drywall
Supply pipe in Burlingame comes in a few distinct generations and each one fails in its own way.
Galvanized steel and old copper, the early houses of Easton Addition, Burlingame Park, Burlingame Terrace and the streets around downtown. Zinc coating wears through, the steel underneath rusts, and the rust builds inward. These lines do not usually burst, they strangle. Pressure falls off gradually over years until the house feels normal to the people living in it and shocking to anyone visiting. These houses often have plaster walls and historic character, so we plan access carefully and patch cleanly.
Midcentury copper and galvanized, the homes of Ray Park, Oak Grove Manor, Mills Estates and the hills. The original supply lines have been in the walls and under the floors for decades, and some of these houses sit on a slab. Copper is sound material, but it does not last forever, and in a slab it sits in a bad location. A pinhole in a wall is a morning of work. The same pinhole under four inches of concrete is a warm patch on the floor and a water bill nobody can explain.
PEX manifolds, remodels and rebuilds. Modern and generally fine. Where we get called here it is usually one bad run or a fitting, not the system, and a full repipe would be selling you something you do not need.
Do Your Pipes Need Replacing?
Four quick questions and a simple magnet test. See what your pipes are likely made of and whether a repipe makes sense.
- About 1 minute
- No email needed
- Instant result
- 1
- 2
- 3
- 4
When was your home built?
A best guess is fine.
Which city is your home in?
Permit requirements depend on the city.
Try the magnet test
Grab any fridge magnet. It takes 30 seconds.
- Find an exposed water pipe: under the kitchen sink, next to the water heater, or where the main line enters the house.
- Wipe off any paint or grime.
- Hold the magnet to the pipe itself. Skip the shutoff valve: valves are usually brass and won't hold a magnet either way.
Have you noticed any of these?
Select all that apply.
Repiping a Slab House Without Breaking Up the Floor
Some Burlingame homes sit on a concrete slab with the original supply lines buried in it. The instinct is to assume a repipe means breaking up the floor, and that is what makes homeowners put the job off for years while the leaks continue.
We do not assume the slab has to be opened. Where the layout allows, we route the new copper and PEX overhead through the attic and drop it down inside the walls, then abandon the old lines in the concrete where they sit. We plan the route at the estimate, so your floors stay where they are. Opening the slab is what we do when the layout genuinely leaves no other path, not as a starting assumption.
Copper & PEX, and Why We Pick One Over the Other
Copper is rigid, long lived and the material most people picture when they think about a repipe. PEX is flexible, which means fewer joints and easier routing through finished walls and around obstacles, and fewer joints means fewer places to ever leak.
Most houses end up with a sensible mix rather than a purist answer, and which mix depends on your layout rather than on what we prefer to install. We walk the house and explain the reasoning before you decide.
Permit, Inspection and Drywall Are Part of the Job
A repipe needs a city permit and a city inspection, and in Burlingame it goes through the city Building Division. One of our people attends the inspection with the documentation.
Access openings are part of repiping, and in older plaster-wall houses we take extra care with them. We plan them rather than discovering them, keeping them to what the routing actually requires, and we patch them when the pipe work is done. You are not left with a finished plumbing system and an unfinished house.
Up to 25 Years on a Whole House Copper Repipe
Our repipe warranty runs up to 25 years. It is our own warranty rather than a manufacturer's, so there is one company standing behind the work and one number to call, and it transfers to a new owner when the plumbing is serviced by JetPipe. No service call, no invoice, no questions.
Financing is available through Synchrony. You pay exactly the amount on our invoice. Subject to credit approval.
Instant Quote
See What Your Repipe Will Cost
Answer a few questions about your home and get a personalized estimate online.
400+ reviews from Bay Area homeowners
Repiping Across Burlingame
We are based in Sunnyvale and serve Burlingame homes, which matters more on a repipe than on a small job, because the crew is on site across several consecutive days.
Easton Addition, Downtown, Burlingame Park, Burlingame Terrace, Lyon Hoag, Burlingame Village, Burlingame Gardens, Ray Park, Oak Grove Manor, Country Club Manor, Mills Estates, Burlingame Hills, Broadway
The map shows where we work most weeks, not a fence. We are based in Sunnyvale and we regularly take jobs in Burlingame. One call tells you whether we can reach you and when.
Do we have to move out while the work happens?
Most families stay in the house. Water goes off in sections rather than all at once, and we sequence the work so at least one bathroom stays usable at the end of each day. We tell you the day before which fixtures will be down.
How many days does a whole house take?
Expect 1 to 3 days for most single family repipes, depending on the project. Access decides more than square footage does. A house with an accessible attic moves faster than an older plaster-wall house where every run has to be opened with care.
Copper or PEX, which would you actually put in your own house?
Usually both, in different parts of the house, which is the honest answer rather than a sales one. Copper on the main runs where it is exposed and accessible, PEX where routing through finished walls would otherwise mean opening three more of them.
What happens to the walls you open?
They are patched as part of the job, and in older plaster-wall houses we keep openings small and plan them ahead. Texture and paint matching beyond the patch is a conversation we have upfront, because a fresh patch on a wall painted years ago will not disappear entirely no matter who does it.
Can you do only part of the house?
Yes, when the pipe age allows it. If one wing was redone at some point and the rest is original, repiping the original half is reasonable. If the whole system is the same age, doing half of it means paying twice for access.
Does a repipe need a permit and an inspection?
Yes. A repipe in Burlingame needs a city permit, and one of our people attends the inspection. You want it done this way, because an unpermitted repipe becomes a problem at the point of sale, when the disclosure asks what work was done and by whom.